Locking and unlocking from the outside
NOTE
If you unlock the driver’s door with a
key and open the door while the alarm
system is armed, the alarm system is
triggered and the vehicle’s horn
sounds. In this case, perform any of
the following operations:
- Press any button on the remote
transmitter.
- Insert the key into the ignition switch and turn the ignition switch to the “ON” position.
For details about the alarm system, refer to “Alarm system”.
To lock the driver’s door from the outside with the key, turn the key toward the rear.
To unlock the door, turn the key toward the front.
Pull the outside door handle to open an unlocked door.
1) Rotate the lock lever rearward.
2) Close the door.
To lock the door from the outside without the key, rotate the lock lever rearward and then close the door.
To lock the door from the outside using the power door locking switch, push the front side of the switch (“LOCK” side) and then close the door. In this case, all closed doors and the rear gate are locked at the same time.
Always make sure that all doors and the rear gate are locked before leaving your vehicle.
NOTE
Make sure that you do not leave the key
inside the vehicle when locking the
doors from the outside without the key.
See also:
Two separate circuits
Your vehicle has two separate circuit
brake systems. Each circuit works diagonally
across the vehicle. If one circuit of
the brake system should fail, the other half
of the system still works. ...
Operation
If the driver and/or front passenger have/ has not yet fastened the seatbelt(s)
when the ignition switch is turned to the “ON” position, the seatbelt warning light(s)
will flash for 6 seconds, to ...
AT OIL TEMP warning light (AT and CVT models)
The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition
switch is turned to the “ON” position and turns off after approximately 2 seconds.
If this light illuminates when t ...