SRS airbag system monitors

Type A
Type A

Type B
Type B

A diagnostic system continually monitors the readiness of the SRS airbag system (including front seatbelt pretensioners) while the vehicle is being driven. The SRS airbag system warning light “AIRBAG” will show normal system operation by lighting for approximately 6 seconds when the ignition switch is turned to the “ON” position.

The following components are monitored by the indicator:
- Front sub sensor
– Right-hand side
– Left-hand side
- Airbag control module (including impact and rollover sensors)
- Frontal airbag module
– Driver’s side
– Front passenger’s side
- Side airbag sensor
– Center pillar right-hand side
– Center pillar left-hand side
- Side airbag module
– Driver’s side
– Front passenger’s side
- Curtain airbag sensor
– Rear wheel house right-hand side
– Rear wheel house left-hand side
- Curtain airbag module
– Right-hand side
– Left-hand side
- Satellite safing sensor (under the rear center seat)
- Seatbelt pretensioner
– Driver’s side
– Front passenger’s side
- Seatbelt buckle switch (front passenger’s side)
- Front passenger’s seatbelt tension sensor
- Front passenger’s occupant detection system weight sensor
- Front passenger’s occupant detection control module
- Front passenger’s frontal airbag ON and OFF indicator
- All related wiring

If the warning light exhibits any of

If the warning light exhibits any of the following conditions, there may be a malfunction in the seatbelt pretensioners and/or SRS airbag system. Immediately take your vehicle to your nearest SUBARU dealer to have the system checked. Unless checked and properly repaired, the seatbelt pretensioners and/or SRS airbag will not operate properly in the event of a collision, which may increase the risk of injury.

- Flashing or flickering of the warning light
- No illumination of the warning light when the ignition switch is first turned to the “ON” position
- Continuous illumination of the warning light
- Illumination of the warning light while driving

    See also:

    Disarming the system
    To disarm the system, briefly press the “” button on the transmitter. ...

    ABS system self-check
    Just after the vehicle is started, you may feel on the brake pedal a vibration similar to when the ABS operates, and you may also hear the sound of the ABS working from the engine compartment. ...

    Starting your vehicle
    NOTE All vehicle doors, the engine hood and trunk / rear gate must be closed prior to activating the remote engine start system. Any open entry point will prevent starting or cause the system t ...