To set cruise control
1. Press the “CRUISE” main switch button.
The cruise control indicator light on the combination meter will illuminate.
2. Depress the accelerator pedal until the vehicle reaches the desired speed.
3. Press the “RES/SET” switch to the “SET” side and release it. Then release the accelerator pedal.
At this time, the cruise control set indicator light is illuminated in the combination meter.
The vehicle will maintain the desired speed.
Vehicle speed can be temporarily increased while driving with the cruise control activated. Simply depress the accelerator pedal to accelerate the vehicle. When the accelerator pedal is released, the vehicle will return to and maintain the previous cruising speed.
See also:
Driving when tired or sleepy
WARNING
When you are tired or sleepy, your reaction will be delayed and your perception,
judgment and attentiveness will be impaired. If you drive when tired or sleepy,
your, your passengers’ and ...
When “NO USB” is displayed (type D audio)
This message is displayed under the
following conditions.
- No USB storage devices/iPod® are
connected.
- A non-connectable USB storage device/
iPod® is connected.
Connect a connectable USB s ...
Door open indicator light
When any of the doors, the rear gate (Outback) or the trunk lid (Legacy) is not
fully closed, the door open indicator light illuminates. This function is effective
even if the ignition switch is ...