To install the cover housing

1. To install the cover housing, insert both ends of the cover housing into the


1. To install the cover housing, insert both ends of the cover housing into the retainers.

2. Make sure to fix the front part of the cargo area cover behind the rear seat.


2. Make sure to fix the front part of the cargo area cover behind the rear seat.

    See also:

    Rear window wiper blade rubber (Outback)
    1. Pull out the end of the blade rubber assembly to unlock it from the plastic support. 2. Pull the blade rubber assembly out of the plastic support. 1) Metal spines 3. If the new blade rub ...

    How to insert a CD (type A)
    While the ignition switch is in the “Acc” or “ON” position, hold a disc with a finger in the center hole while gripping the edge of the disc, then insert it in to the slot (with the label side up) ...

    Lubrication oil circulation in the refrigerant circuit
    Operate the air conditioner compressor at a low engine speed (at idle or low driving speeds) a few minutes each month during the off-season to circulate its oil. ...