Gear position indicator setting (MT models)

The gear position indicator light can be activated or deactivated by performing the following procedure.

1. Turn the ignition switch to the “LOCK” position.

2. Press the trip knob to show “ ” or “ ” on the trip meter display.

The display can be switched as shown in the following illustration by pressing the trip knob.

3. To change the current setting, press the trip knob for at least 2 seconds.


3. To change the current setting, press the trip knob for at least 2 seconds.

NOTE

● The initial setting for your vehicle of the gear position indicator has been set for activation “shipment from the factory.” at the time of
shipment from the factory.

● It is not possible to change the setting of the gear position indicator when the ignition switch is in the “ON” position. Change the setting when the ignition switch is in the “LOCK” or “Acc” position.

    See also:

    Defogger and deicer
    1) Rear window defogger 2) Outside mirror defogger (if equipped) 3) Windshield wiper deicer (if equipped) The vehicle is equipped with a rear window defogger. Some models are also equipped with ...

    Jump starting
    WARNING ● Battery fluid is SULFURIC ACID. Do not let it come in contact with the eyes, skin, clothing or the vehicle. If battery fluid gets on you, thoroughly flush the exposed area with wat ...

    Measuring and adjusting air pressure to achieve proper inflation
    Check and, if necessary, adjust the pressure of each tire (including the spare) at least once a month and before any long journey. Check the tire pressures when the tires are cold. Use a pressure ...