Canceling the function for meter/gauge needle movement upon turning on the ignition switch
It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition switch to the “LOCK” or “Acc” position.
2. Press the trip knob to show “ ” or “ ” on the trip meter display
The display can be switched as shown in the following illustration by pressing the trip knob.
3. To change the current setting, press the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
● Your vehicle’s initial movement setting of the meter/gauge needles has been set for activation “ ” at the time of shipment from the factory.
● It is not possible to change the initial movement setting of the meter/gauge needles when the ignition switch is in the “ON” position. Change the setting when the ignition switch is in the “LOCK” or “Acc” position.
See also:
Tilt/telescopic steering wheel
WARNING
Do not adjust the steering wheel tilt/ telescopic position while driving. This
may cause loss of vehicle control and result in personal injury.
1. Adjust the seat position. Refer to “Fro ...
Front passenger’s frontal airbag ON and OFF indicators
Front passenger’s frontal
airbag ON indicator
Front passenger’s frontal airbag
OFF indicator
The front passenger’s frontal airbag ON and OFF indicators show you the status of the front passe ...
How to jump start
1. Make sure the booster battery is 12 volts and the negative terminal is grounded.
2. If the booster battery is in another vehicle, do not let the two vehicles
touch.
3. Turn off all unnecessary ...