Deleting old transmitter codes
The control unit of the remote keyless entry system has four memory locations to store transmitter codes, giving it the ability to operate with up to four transmitters. When you lose a transmitter, the lost transmitter’s code remains in the memory.
For security reasons, lost transmitter codes should be deleted from the memory. To delete old transmitter codes, program four transmitter codes into the system. If you have only one current transmitter, program it four times. If you have two current transmitters, program each one twice. If you have three current transmitters, program two of them once and the third one twice. This process will leave only current transmitter codes in the system’s memory.
NOTE
Make sure no one else is operating their remote keyless entry system within range of your vehicle when programming transmitters. If someone else were to operate their remote transmitter while you are programming your transmitters, it is possible that their transmitter code will be programmed into your system, allowing them unauthorized access to your vehicle.
See also:
To turn off the cruise control
There are two ways to turn off the cruise control:
● Press the “CRUISE” main switch button again.
● Turn the ignition switch to the “Acc” or “LOCK” position (but only when the
vehicle ...
Front seats
- Never adjust the seat while driving
to avoid the possibility of
loss of vehicle control and of
personal injury.
- Before adjusting the seat, make
sure the hands and feet of rear
seat ...
Vanity mirror with light
CAUTION
Keep the vanity mirror cover closed while the car is being driven to avoid being
blinded by glare.
To use the vanity mirror, swing down the sun visor and open the vanity mirror
cover. ...
