Sounding a panic alarm
To activate the alarm, press the “PANIC” button once.
The horn will sound and the turn signal lights will flash.
To deactivate the panic alarm, press any button on the remote transmitter. If a button on the remote transmitter is not pressed, the alarm will be deactivated after approximately 30 seconds.
See also:
Pulling off the fender lining
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the eng ...
Passive arming
When passive arming mode has been programmed by the dealer, arming of the system
is automatically accomplished without using the remote transmitter. Note that in
this mode, DOORS MUST BE MANUALLY ...
Folder selection (only when connecting USB storage device)
Refer to “Folder selection”.
NOTE
When an iPod® is connected, you cannot select a folder. ...