Behavior with key lock-in prevention function non-operational
● If the lock lever is turned to the rear (“LOCK”) position with the driver’s door open and the driver’s door is then closed with the lock lever in that position, the driver’s door is locked. . If the spare key is used to lock the driver’s door from the outside of the vehicle, the door is locked. This function’s operational/non-operational setting can be changed by a SUBARU dealer. Contact a SUBARU dealer for details.
NOTE
● The factory setting (default setting) for this function is set as “operational”.
● When leaving the vehicle, make sure you are holding the key before locking the doors.
See also:
Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the “ON” position, the low tire pressure warning light will illuminate for approximately 2 seconds to check that the tire pressure monitoring system (TPMS) is f ...
Exterior
1) Engine hood
2) Headlight switch
3) Replacing bulbs
4) Wiper switch
5) Moonroof
6) Roof rail
7) Door locks
8) Tire pressure
9) Flat tires
10) Tire chains
11) Front fog light ...
Selection of manual mode
With the vehicle either moving or stationary, move the select lever from the
“D” position to the “M” position to select the manual mode.
1) Upshift indicator
2) Downshift indicator
3) Gear po ...
