Subaru Outback (BR): Outback License plate light
1. Remove the mounting screws using a Phillips screwdriver.
2. Remove the lens.
3. Pull the bulb out of the socket.
4. Install a new bulb.
5. Reinstall the lens.
6. Tighten the mounting screws.
READ NEXT:
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically.
3. Pull the bulb stra
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straigh
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
SEE MORE:
Chemicals, salts and gravel used for deicing road surfaces are extremely corrosive,
accelerating the corrosion of underbody components, such as the exhaust system,
fuel and brake lines, brake cables, floor pan and fenders, and suspension. Thoroughly
flush the underbody and inside of the fender
Tongue load
WARNING
If the trailer is loaded with more weight in the back of trailer’s axle than
in the front, the load is taken off the rear axle of the towing vehicle. This may
cause the rear wheels to skid, especially during braking or when vehicle speed is
reduced during cornering, r
© 2010-2024 Copyright www.suoutback.com