Subaru Outback (BR): Tail/Back-up light (Outback)
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Replacing bulbs / Tail/Back-up light (Outback)
1. Apply a flat-head screwdriver to the light cover as shown in the illustration, and pry the light cover off from the rear gate trim.
1) Back-up light
2) Tail light
2. Turn the bulb socket counterclockwise and remove it.
3. Pull the bulb out of the bulb socket and replace it with a new one.
4. Install the bulb socket by turning it clockwise.
5. Install the light cover on the rear gate.
READ NEXT:
Outback License plate light
1. Remove the mounting screws using a Phillips screwdriver.
2. Remove the lens.
3. Pull the bulb out of the socket.
4. Install a new bulb.
5. Reinstall the lens.
6. Tighten th
Dome light remove bulb
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically.
3. Pull the bulb stra
SEE MORE:
Rear gate (Outback) – if the rear gate cannot be unlocked
In the event that you cannot unlock the rear gate by operating the power door
locking switches or the remote keyless entry system, you can unlock it from inside
the cargo area.
1. Remove the access cover at the bottom-center of the rear gate trim using flat-head
screwdriver.
2. Locate the
Brake Hose
A: REMOVAL
1. FRONT BRAKE HOSE
1) Separate the brake pipe (b) from brake hose (a) using a flare nut wrench.
2) Remove the clamp, strut mounting bolt and union bolt, and remove the front
brake hose.
2. REAR BRAKE HOSE
1) Remove the brake hose bracket bolt and union bolt.
2) Separate the brake pip
© 2010-2024 Copyright www.suoutback.com
