Subaru Outback (BR): Front fog light (if equipped)
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Pull off the fender lining. Refer to “Pulling off the fender lining” F11-7.
2. Disconnect the electrical connector.
1) For left-hand side
2) For right-hand side
3. Turn the socket clockwise (right-hand side) or counterclockwise (left-hand
side).
4. Pull out the socket.
5. Pull out the bulb from the socket and replace the bulb with a new one.
6. After replacing the bulb, reattach the fender lining.
READ NEXT:
Legacy
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn the knobs of the cover 90 degrees counterclockwis
1. Apply a flat-head screwdriver to the light cover as shown in the illustration,
and pry the light cover off from the rear gate trim.
1) Back-up light
2) Tail light
2. Turn the bulb socket c
SEE MORE:
WARNING
Snow can trap dangerous exhaust gases under your vehicle. Keep snow clear of
the exhaust pipe and from around your vehicle if you park the vehicle in snow with
the engine running.
Do not use the parking brake when parking for long periods in cold weather since
it could freeze in that
AT models
1) Yellow handle
1. Park the vehicle on a level surface and stop the engine.
2. Pull out the level gauge, wipe it clean, and insert it again.
1) Upper level
2) Lower level
3. Pull out the level gauge again and check the oil level on it. If it is below the lower l
© 2010-2024 Copyright www.suoutback.com