Subaru Outback (BR): Headlight
CAUTION
Halogen headlight bulbs become very hot while in use. If you touch the bulb surface
with bare hands or greasy gloves, fingerprints or grease on the bulb surface will
develop into hot spots, causing the bulb to break. If there are fingerprints or
grease on the bulb surface, wipe them away with a soft cloth moistened with alcohol.
NOTE
● If headlight aiming is required, consult your SUBARU dealer for proper adjustment
of the headlight aim.
● It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
READ NEXT:
1. Pull off the fender lining. For details, refer to “Pulling off the fender
lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connecto
1. Remove the air intake duct (right-hand side). For the method to remove the
air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the se
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn over the protective cover of the engine compartment.
2
SEE MORE:
A: REMOVAL
NOTE:
For removal of reverse brake assembly, refer to "Intermediate Case". <Ref. to
CVT-165, REMOVAL, Intermediate
Case.>
B: INSTALLATION
NOTE:
For removal of reverse brake assembly, refer to "Intermediate Case". <Ref. to
CVT-166, INSTALLATION, Intermediate
Case.>
C: DISASSE
AB:DTC P0131 O2 SENSOR CIRCUIT LOW VOLTAGE (BANK 1 SENSOR 1)
1. OUTLINE OF DIAGNOSIS
Detect the open or short circuit of sensor.
Judge as NG, when the element voltage is out of the specified range.
2. COMPONENT DESCRIPTION
Electromotive force
Air fuel ratio
Lean
Rich
Exhaust gas
ZrO2
3.
© 2010-2024 Copyright www.suoutback.com