Subaru Outback manuals

Subaru Outback (BR): Replacing bulbs

WARNING

Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down, Otherwise, there is the risk of sustaining a burn injury.

CAUTION

Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to “Bulb chart” F12-14.

READ NEXT:

 Headlight

CAUTION Halogen headlight bulbs become very hot while in use. If you touch the bulb surface with bare hands or greasy gloves, fingerprints or grease on the bulb surface will develop into hot spot

 Low beam light bulbs

1. Pull off the fender lining. For details, refer to “Pulling off the fender lining” F11- 7. 2. Remove the bulb cover, by turning it counterclockwise. 3. Disconnect the electrical connecto

 High beam light bulbs

1. Remove the air intake duct (right-hand side). For the method to remove the air intake duct, refer to “Removing air intake duct” F11-7. Left-hand side 2. Use a screwdriver to remove the se

SEE MORE:

 Extension Case Oil Seal

A: INSPECTION Inspect there is no ATF leakage from the joint of transmission and propeller shaft. If a leak is found, replace the oil seal. <Ref. to 5AT-48, REPLACEMENT, Extension Case Oil Seal.> B: REPLACEMENT 1) Lift up the vehicle. 2) Clean the transmission exterior. 3) Remove the ATF dra

 Woofer

A: REMOVAL 1. SEDAN MODEL NOTE: harman/kardon audio system only. 1) Disconnect the ground cable from battery. 2) Remove the rear shelf trim. <Ref. to EI-120, REMOVAL, Rear Shelf Trim.> 3) Remove the woofer. Remove the screws. Disconnect the harness connector and remove the woofer assembly

© 2010-2024 Copyright www.suoutback.com