Subaru Outback (BR): Using a warm water washer
● Keep a good distance of 12 in (30 cm) or more between the washer nozzle and
the vehicle.
● Do not wash the same area continuously.
● If a stain will not come out easily, wash by hand. Some warm water washers are
of the high temperature, high pressure type, and they can damage or deform the resin
parts such as mouldings, or cause water to leak into the vehicle.
READ NEXT:
Always wash and dry the vehicle before waxing and polishing.
Use a good quality polish and wax and apply them according to the manufacturer’s
instructions. Wax or polish when the painted surface
● Promptly wipe the aluminum wheels clean of any kind of grime or agent. If dirt
is left on too long, it may be difficult to clean off.
● Do not use soap containing grit to clean the wh
Your SUBARU has been designed and built to resist corrosion. Special materials
and protective finishes have been used on most parts of the vehicle to help maintain
fine appearance, strength, and r
SEE MORE:
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle, and then remove the front wheels.
3) Remove the front ABS wheel speed sensor.
CAUTION:
Be careful not to damage the sensor.
Do not apply excessive force to the sensor harness.
Disconnect the front ABS wheel speed
A: REMOVAL
1) Remove the door trim. <Ref. to EI-60, REMOVAL, Door Trim.>
2) Remove the screws and detach the rear inner remote handle.
B: INSTALLATION
1) Before installation, check the following items.
Cable is free from deformation such as fray.
Grease is applied sufficiently to cable jo
© 2010-2024 Copyright www.suoutback.com