Subaru Outback: To set cruise control
1. Press the “CRUISE” main switch button.
The cruise control indicator light on the combination meter will illuminate.
2. Depress the accelerator pedal until the vehicle reaches the desired speed.
3. Press the “RES/SET” switch to the “SET” side and release it. Then release
the accelerator pedal.
At this time, the cruise control set indicator light is illuminated in the combination
meter.
The vehicle will maintain the desired speed.
Vehicle speed can be temporarily increased while driving with the cruise control
activated. Simply depress the accelerator pedal to accelerate the vehicle. When
the accelerator pedal is released, the vehicle will return to and maintain the previous
cruising speed.
READ NEXT:
The cruise control can be temporarily canceled in the following ways.
● Press the “CANCEL” button.
● Depress the brake pedal.
● Depress the clutch pedal (MT models only).
&
There are two ways to turn off the cruise control:
● Press the “CRUISE” main switch button again.
● Turn the ignition switch to the “Acc” or “LOCK” position (but only when th
SEE MORE:
The tachometer shows the engine speed in thousands of revolutions per minute.
CAUTION
Do not operate the engine with the pointer of the tachometer in the red zone.
In this range, fuel injection will be cut by the engine control module to protect
the engine from overrevving. The engine will res
A: REMOVAL
1) Lift up the vehicle, and then remove the rear wheels.
2) Remove the trailing link.
Remove the bracket, and remove the parking brake cable from the guide
(a).
Remove the bolts and nuts, and then remove the trailing link.
3) Remove the front lateral link.
Remove the snap pin (a
© 2010-2024 Copyright www.suoutback.com