Subaru Outback (BR): Vehicle Dynamics Control system monitor
READ NEXT:
The light illuminates when the ignition switch is turned to the “ON” position
and turns off several seconds after the engine has started. This lighting pattern
indicates that the Vehicle Dyn
The light will turn on when the ignition switch is set to the "ON" position and will automatically turn off after about 2 seconds. Additionally, the light will illuminate if the Vehicle Dy
Pressing the switch to deactivate the Vehicle Dynamics Control system can facilitate
the following operations.
● a standing start on a steeply sloping road with a snowy, gravel-covered, or
SEE MORE:
A: REMOVAL
1) Remove the transmission assembly from vehicle body. <Ref. to CVT-55,
REMOVAL, Automatic Transmission
Assembly.>
2) Remove the extension case. <Ref. to CVT-138, REMOVAL, Extension Case.>
3) Remove the rear drive shaft. <Ref. to CVT-141, REMOVAL, Rear Drive Shaft.>
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Using the refrigerant recovery system, discharge refrigerant. <Ref. to AC-24,
PROCEDURE, Refrigerant
Recovery Procedure.>
3) Remove the connector and bolts, and remove the high-pressure hose and AC pipe
from the expansion
valve.
4
© 2010-2024 Copyright www.suoutback.com