Subaru Outback (BR): How to use the rear view camera
When the shift lever or select lever is set to “R”, the rear view camera automatically
displays the rear view image from the vehicle. When the lever is set to other positions,
the image before setting to “R” is displayed.
1. Set the ignition switch to “ON”.
2. Set the shift lever or select lever to “R”.
NOTE
● For models with the genuine SUBARU navigation system, the image of the rear
view camera has priority over other screen displays. To operate other screens, set
the shift lever (MT models) or select lever (AT and CVT models) to a position other
than “R”.
● The image of the rear view camera is horizontally reversed as is the case with
the vehicle rearview mirror or the side view mirror.
● It may be difficult to see the image of the rearview camera in the following
cases. This is not a malfunction of the camera.
– The vehicle is in a dark place (at night, in a tunnel, etc.).
– The vehicle is in an extremely hot or cold place.
– An object (such as raindrops, snow, dirt, etc.) that disturbs the view of the
rear view camera sticks to the lens of the camera.
– Strong light shined directly on the camera lens (occasionally, there are vertical
lines on the screen).
READ NEXT:
Range of view
Range of view
Image from camera
The area from the rear end of the bumper can be viewed. Areas at both ends of
the bumper and areas just under the bumper cannot be viewed.
Als
The help line (distance marker and vehicle width line) is a guide to help you
realize the actual distance from the screen.
Help lines displayed on the navigation monitor
Help lines displayed o
The distance markers show the distance for a level road when the vehicle is not
loaded. It may be different from the actual distance depending on the loading conditions
or road conditions.
When t
SEE MORE:
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn over the protective cover of the engine compartment.
2. Turn the socket counterclockwise and pull it out.
3. Pull out the bulb from the socket and replac
1) Key number plate
2) Security ID plate
The key number is stamped on the key number plate attached to the key set.
Write down the key number and keep it in another safe place, not in the vehicle.
This number is needed to make a replacement key if you lose your key or lock it
inside the veh
© 2010-2024 Copyright www.suoutback.com