Subaru Outback (BR): CD player operation
NOTE
● Make sure to always insert a disc with the label side up. If a disc is inserted with the label side down, the player displays “CHECK DISC”. Refer to “When the following messages are displayed” F5-27.
● If a disc is inserted during a radio broadcast, the disc will interrupt the broadcast.
● After the last track finishes, the disc will automatically return to track 1 (the first track on the disc) and will automatically play back.
● The player is designed to be able to play music CD-Rs and music CD-RWs, but it may not be able to play certain ones.
● CDs (i.e., 8 cm/3 inch CDs) are not supported, and if inserted, they will be immediately ejected.
● Copyright protected WMA/AAC files will not be played by the system. The player will automatically skip to the next file (track).
● Audio data recorded in the MP3/ WMA/AAC formats may not be played depending on the data recording condition.
- How to insert a CD (type A)
- How to insert a CD(s) (type B)
- How to play back a CD
- To select a track from its beginning
- Fast-forwarding and fast-reversing
- Repeating
- Random playback
- Scan
- Display selection in CD player
- Folder selection
- How to eject a CD from the player (type A)
- How to eject CDs from the player (type B)
- When the following messages are displayed
READ NEXT:
How to insert a CD (type A)
While the ignition switch is in the “Acc” or “ON” position, hold a disc with
a finger in the center hole while gripping the edge of the disc, then insert it
in to the slot (with the label
How to insert a CD(s) (type B)
1. Briefly press the “LOAD” button. If the magazine in the player has an idle
position where you can insert a disc, the disc number indicator associated with
the idle position will blink.
I
Inserting a disc in a desired position
1. Briefly press the “LOAD” button. If the magazine in the player has an idle
position where you can insert a disc, the disc number indicator associated with
the idle position will blink.
T
SEE MORE:
Moonroof – if moonroof cannot be closed
If the moonroof cannot be closed with the moonroof switch, you can close the
moonroof manually.
1. Take out the screwdriver from the tool bucket.
2. Open the overhead console. Refer to “Overhead console” F6-8.
3. Remove the two screws that retain the moonroof switch body. Then, remove the
Clutch Pedal
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the collector cover. (turbo model)
3) Remove the air intake boot assembly. (non-turbo
model) <Ref. to IN(H4SO)-8, INSTALLATION,
Air Intake Boot.>
4) Remove the intercooler. (turbo model) <Ref. to
IN(H4DOTC)-17, REMOVAL,
