Subaru Outback (BR): How to preset stations
1. Press the “FM” or “AM” button to select FM1, FM2, FM3 or AM reception. 2.
Press the “” or “”
side of the “SEEK” button or tune the radio manually until the desired station frequency
is displayed. 3. Press one of the preset buttons for more than 1.5 seconds to store
the frequency. If the button is pressed for less than 1.5 seconds, the preceding
selection will remain in memory.
NOTE
● If the connection between the radio and battery is broken for any reason such
as vehicle maintenance or radio removal, all stations stored in the preset buttons
are cleared. If this occurs, it is necessary to reset the preset stations. . If
a cell phone is placed near the radio, it may cause the radio to emit noise when
the phone receives calls. This noise does not indicate a radio malfunction.
READ NEXT:
Presetting a station with a preset button allows you to select that station in
a single operation. Up to six AM, FM1, FM2 and FM3 stations each may be preset.
Using the Auto-store function, you can automatically store 6 stations on the
current waveband by pressing the “A.S” button for more than 2 seconds. Use Autostore
to quickly find the stronges
To receive satellite radio, it is necessary to install the SUBARU genuine satellite
receiver for some models, and to enter into a contract with a satellite radio network
service such as “XMTM sa
SEE MORE:
The load capacity of your vehicle is determined by weight, not by available cargo
space. The load limit of your vehicle is shown on the vehicle placard attached to
the driver’s side B-pillar. Locate the statement “The combined weight of occupants
and cargo should never exceed XXX kg or XXX
Basic Diagnostic Procedure
A: PROCEDURE
General Description
A: CAUTION
CAUTION:
Do not use electrical test devices on any airbag
system wiring harnesses and connector
circuits.
Be careful not to damage the airbag system
wiring harness.
While diagnostic items are being checked, do
not opera
© 2010-2024 Copyright www.suoutback.com