Subaru Outback (BR): Printed antenna
CAUTION
Do not use sharp instruments or window cleaner containing abrasives to clean
the inner surface of the window on which the antenna is printed. Doing so may damage
the antenna printed on the window.
The antenna is printed on the inner surface of the rear window glass.
NOTE
Antenna performance will deteriorate significantly if you apply tinting film
or any other material over the antenna portion of the rear window glass.
READ NEXT:
Although FM is normally static free, reception can be affected by the surrounding
area, atmospheric conditions, station strength and transmitter distance. Buildings
or other obstructions may cause
Your SUBARU may be equipped with one of the following audio sets. See the pages
indicated in this section for operating details.
NOTE
If a cell phone is placed near the audio set, it may cause the
SEE MORE:
A: REMOVAL
1) Lift up the vehicle, and then remove the front wheels.
2) Remove the front arm.
Remove the nut and disconnect the front stabilizer link.
Remove the bolt, and then remove the ball joint for the front arm.
Remove the bolts, then remove the front arm.
B: INSTALLATION
1) Before i
If the light is blinking while driving, an engine misfire condition has been
detected which may damage the emission control system.
To prevent serious damage to the emission control system, you should conform
to the following instructions.
● Reduce vehicle speed.
● Avoid hard acce
© 2010-2024 Copyright www.suoutback.com