Subaru Outback (BR): Air inlet selection button (Automatic climate control system)
Select airflow by pressing the air inlet selection button “
”.
ON position (recirculation): Interior air is recirculated inside the vehicle. Press the air inlet selection button to the ON position for fast cooling with the air conditioner or when driving on a dusty road. The indicator light will illuminate.
OFF position (outside Air): Outside air is drawn into the passenger compartment. Press the air inlet selection button to the OFF position when the interior has cooled to a comfortable temperature and the road is no longer dusty. The indicator light will turn off.
WARNING
Continued operation in the ON position (recirculation) may fog up the windows. Switch to the OFF position (outside air) as soon as the outside dusty condition clears.
NOTE
When driving on a dusty road or behind a vehicle that emits unpleasant exhaust gases, set the air inlet selection button to the ON position (recirculation).
From time to time, return the air inlet selection button to the OFF position (outside air) to draw outside air into the passenger compartment.
READ NEXT:
Temperature sensors
1) Solar sensor
2) Interior air temperature sensor
The automatic climate control system employs several sensors. These sensors are
delicate. If they are treated incorrectly and become damaged, t
Cleaning ventilator grille
Always keep the front ventilator inlet grille free of snow, leaves, or other
obstructions to ensure efficient heating and defrosting. Since the condenser is
located in front of the radiator, thi
SEE MORE:
Front passenger’s SRS frontal airbag
The front passenger’s SRS frontal airbag uses a dual stage inflator. The inflator
operates in different ways depending on the severity of impact.
The total load on the seat is monitored by the passenger’s occupant detection
system weight sensor under the seat.
Using the total seat load and
Front Fender
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the bumper face assembly.
Remove the clips, turn over the front mud guard, and disconnect the fog
light connector. (Model with
fog light)
Remove the clips at the upper side of the bumper.
Remove the clips from the fender.
