Subaru Outback: Compass calibration
1. If a “C” is displayed in the compass window, the compass needs to be calibrated.
2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads
a direction.
3. You can also calibrate the compass by driving your vehicle on your everyday routine.
The compass will be calibrated once it has tracked a complete circle.
4. To recalibrate your compass, push and hold the switch for 9 seconds until a “C”
appears in the compass window.
5. Calibrate the compass according to step 2 or step 3.
READ NEXT:
1) HomeLink® button 1
2) HomeLink® button 2
3) LED
4) HomeLink® button 3
5) Sensor
6) Automatic dimming on/off button
7) Compass display button
8) Compass display
The auto-dimming mirror
The mirror has a photosensor attached on both the front and back sides. During
nighttime driving, these sensors detect distracting glare from vehicle headlights
behind you and automatically dim
Compass calibration zones
1. Refer to the “Compass calibration zones” map shown above to verify that the
compass zone setting is correct for your geographical location.
2. Press and hold the
SEE MORE:
To wash the rear window while the rear wiper is operating, turn the knob on the
end of the wiper control lever upward to the “”
position. The washer fluid sprays until you release the knob. To wash the rear window
when the rear wiper is not in use, turn the knob on the end of the wiper con
A: CAUTION
Before disassembling or reassembling parts, always disconnect the
battery ground cable from battery.
When replacing the audio, control module and other parts provided with
memory functions, record the memory
contents before disconnecting the battery ground cable. Otherwise, the
© 2010-2024 Copyright www.suoutback.com