Subaru Outback (BR): Windshield washer
To wash the windshield, pull the wiper control lever toward you. The washer fluid
sprays until you release the lever. The wipers operate while you pull the lever.
NOTE
The windshield washer fluid warning light illuminates when the washer fluid level
in the tank has dropped to the lower limit. If the warning light illuminates, refill
the tank with fluid. For the tank refilling method, refer to “Windshield washer
fluid” F11-40.
READ NEXT:
: Washer (accompanied by wiper operation)
ON: Continuous INT: Intermittent OFF: Off
: Washer (accompanied by wiper operation)
To turn the rear wiper on, turn the knob on the end of the wiper control lever
upward to the “INT” or “ON” position. To turn the wiper off, return the knob on
the end of the lever to the
To wash the rear window while the rear wiper is operating, turn the knob on the
end of the wiper control lever upward to the “”
position. The washer fluid sprays until you release the knob. To
SEE MORE:
When the ignition switch is turned to the “ON” position, the various parts of
the combination meter are illuminated in the following sequence.
1. Warning lights, indicator lights, meter needles, gauge needles, odometer and
trip meter back light illuminate.
2. Meter needles and gauge needle
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 6MT-25, REMOVAL,
Manual Transmission Assembly.>
2) Remove the back-up light switch and the neutral
position switch. <Ref. to 6MT-37, REMOVAL,
Switches and Harness.>
3) Remove the transfer case together wit
© 2010-2024 Copyright www.suoutback.com