Subaru Outback (BR): Daytime running light system
WARNING
The brightness of the illumination of the high beam headlights is reduced by
the daytime running light system. The light switch must always be turned to the
“” position when it is dark outside.
The high beam headlights will automatically illuminate at reduced brightness
when the engine has started, under the following conditions.
● The parking brake is fully released.
● The light switch is in the “OFF” or “ ” position.
● The light switch is in the “AUTO” position and the headlights do not turn on automatically.
● The select lever is in a position other than the “P” position (AT and CVT models).
NOTE
When the light switch is in the “ ” position, the front side marker lights, tail
lights and license plate lights are illuminated.
READ NEXT:
To activate the right turn signal, push the turn signal lever up. To activate
the left turn signal, push the turn signal lever down. When the turn is finished,
the lever will return automaticall
The illumination brightness of the clock display, audio, air conditioner, multi
function display and meter/gauge dims under the following conditions.
● when the light switch is in the “
The front fog lights operate under the following conditions.
● when the light switch is in the “”
position
● when the light switch is in the “AUTO” position and the headlight
SEE MORE:
If you remove the divider plate from the dual cup holders, you can use the center
console box as a storage space.
To use as storage space:
Pull out the divider plate of the dual cup holder.
To use again as cup holders:
Insert the divider plate into the console box.
A: REMOVAL
1) Remove the front bumper face assembly.
Remove the clips, turn over the front mud guard, and disconnect the fog
light connector. (Model with
fog light)
Remove the clips at the upper side of the bumper.
Remove the clips from the fender.
Remove the clips at the lower side of bu
© 2010-2024 Copyright www.suoutback.com