Subaru Outback (BR): Sensor for the auto on/off headlights
The sensor is on the instrument panel as shown in the illustration.
CAUTION
If any object is placed on or near the sensor, the sensor may not detect the
level of the ambient light correctly and the auto on/off headlights may not operate
properly.
READ NEXT:
To change from low beam to high beam, push the turn signal lever forward. When
the headlights are on high beam, the high beam indicator light “”
on the combination meter is also on.
To swit
CAUTION
Do not hold the lever in the flashing position for more than just a few seconds.
To flash the headlights, pull the lever toward you and then release it. The high
beam will stay on for as
WARNING
The brightness of the illumination of the high beam headlights is reduced by
the daytime running light system. The light switch must always be turned to the
“” position when it is dar
SEE MORE:
A: REMOVAL
1. CENTER PANEL ASSY
1) Attach the protective tape (a) to the meter visor.
2) Remove the center panel assembly.
CAUTION:
Do not put your finger on the fin of the air vent grille. Doing so may damage
the fin.
Attach the protective tape (a) to the meter visor.
Insert a finger into t
WARNING
Objects look smaller in a convex mirror and farther away than when viewed in
a flat mirror. Do not use the convex mirror to judge the distance of vehicles behind
you when changing lanes. Use the inside mirror (or glance backwards) to determine
the actual size and distance of objects t
© 2010-2024 Copyright www.suoutback.com