Subaru Outback (BR): Upshift/downshift indicator (AT and CVT models)
When the manual mode is selected, the gear position indicator (which shows the
current gear selection) and the upshift/ downshift indicator light up. Refer to
“Automatic transmission/Continuously variable transmission” F7-18.
READ NEXT:
The gear position indicator light can be activated or deactivated by performing
the following procedure.
1. Turn the ignition switch to the “LOCK” position.
2. Press the trip knob to show “
These lights show the operation of the turn signal or lane change signal.
If the indicator lights do not blink or blink rapidly, the turn signal bulb may
be burned out. Replace the bulb as soon a
This light shows that the headlights are in the high beam mode.
This indicator light also illuminates when the headlight flasher is operated.
SEE MORE:
When the ignition switch is turned to the “ON” position, the low tire pressure
warning light will illuminate for approximately 2 seconds to check that the tire
pressure monitoring system (TPMS) is functioning properly. If there is no problem
and all tires are properly inflated, the light
When the fluid level has to be checked without time to warm up the automatic
transmission, check to see that the fluid level is between the lower level and upper
level on the “COLD” range. If it is below that range, add fluid up to the upper
level. Be careful not to overfill.
CAUTION
Be
© 2010-2024 Copyright www.suoutback.com