Subaru Outback: Alarm system
It blinks to show the driver the operational status of the alarm system. For
detailed information, refer to “Alarm system” F2- 15.
READ NEXT:
This light blinks approximately 60 seconds after the ignition switch is turned
from “ON” position to the “Acc” or “LOCK” position or immediately after the key
is pulled out. Refer to
1) Upshift/downshift indicator (AT and CVT models)
This indicator shows the position of the shift lever (MT models) or select lever
(AT and CVT models).
When the manual mode is selected, the gear position indicator (which shows the
current gear selection) and the upshift/ downshift indicator light up. Refer to
“Automatic transmission/Continuousl
SEE MORE:
A: REMOVAL
1. FRONT DOOR
1) Disconnect the ground cable from battery.
2) Remove the gusset cover.
Attach the protective tape (a) to the door trim.
Release the clips and claws, then detach the gusset cover.
3) Remove the front door trim assembly.
Open the cover and remove the screw.
Remove t
CA:DTC P0453 EVAPORATIVE EMISSION CONTROL SYSTEM PRESSURE
SENSOR HIGH INPUT
DTC DETECTING CONDITION:
Immediately at fault recognition
GENERAL DESCRIPTION <Ref. to GD(H4SO)-165, DTC P0453 EVAPORATIVE
EMISSION CONTROL
SYSTEM PRESSURE SENSOR HIGH INPUT, Diagnostic Trouble Code (DTC) Detecting
© 2010-2024 Copyright www.suoutback.com