Subaru Outback: Security indicator light
This indicator light shows the status of the alarm system. It also indicates
operation of the immobilizer system.
READ NEXT:
It blinks to show the driver the operational status of the alarm system. For
detailed information, refer to “Alarm system” F2- 15.
This light blinks approximately 60 seconds after the ignition switch is turned
from “ON” position to the “Acc” or “LOCK” position or immediately after the key
is pulled out. Refer to
1) Upshift/downshift indicator (AT and CVT models)
This indicator shows the position of the shift lever (MT models) or select lever
(AT and CVT models).
SEE MORE:
General Description
A: GENERAL DESCRIPTION
Be sure to perform periodic maintenance in order to
maintain vehicle performance and find problems
before they occur.
Schedule
A: MAINTENANCE SCHEDULE 1
1. MODEL WITH US SPECIFICATION
Other than U5 model
Symbols used:
R: Replace
I: Inspection
P: Perfo
A: REMOVAL
1) Lift up the vehicle, and then remove the front wheels.
2) Remove the axle nut.
CAUTION:
Do not loosen the axle nut while the front axle is loaded. Doing so may damage
the hub bearing.
Lift the crimped section of axle nut.
Remove the axle nut using a socket wrench while depressing
© 2010-2024 Copyright www.suoutback.com