Subaru Outback (BR): Hill Holder indicator light
WARNING
If the Hill Holder indicator light does not illuminate even when the Hill Holder
switch is pressed to activate the Hill Holder function, the electronic parking brake
system may be malfunctioning. Immediately stop the vehicle in a safe location and
contact your SUBARU dealer.
The light illuminates when the ignition switch is turned to the “ON” position
and turns off after approximately 2 seconds.
The light illuminates when the Hill Holder switch is pressed to activate the
Hill Holder function.
READ NEXT:
The low fuel warning light illuminates when the tank is nearly empty approximately
2.6 US gal (10.0 liters, or 2.2 Imp gal). It only operates when the ignition switch
is in the “ON” position
When the ignition switch is in the “ON” position, the door open warning light
illuminates for approximately 2 seconds and then turns off.
The door open warning light illuminates if any door,
When any of the doors, the rear gate (Outback) or the trunk lid (Legacy) is not
fully closed, the door open indicator light illuminates. This function is effective
even if the ignition switch is
SEE MORE:
A: SPECIFICATION
Refer to "SPECIFICATIONS" in "FRONT SUSPENSION" section for rear suspension specifications. <Ref. to FS-2, SPECIFICATION, General Description.>
NOTE:
Front toe-in, rear toe-in and front camber can be adjusted. Adjust if the value of toe-in or ca
A: LOCATION
TCM ("P" range)
Body integrated unit
Stop light switch
Key cylinder (with built-in key
warning switch)
Solenoid unit
"P" range switch
Key lock solenoid
B: ELECTRICAL SPECIFICATION
*1: Measuring condition
Output signal for key lock solenoid (unlock)
Output signal for key l
© 2010-2024 Copyright www.suoutback.com