Subaru Outback (BR): Coolant temperature low indicator light/Coolant temperature high warning light
CAUTION
● After turning the ignition switch to the “ON” position, if this indicator light/warning light behaves under any of the following conditions, the electrical system may be malfunctioning. Contact your SUBARU dealer immediately for an inspection.
– It remains blinking in RED.
– It remains illuminated in RED for more than 2 seconds.
– It remains blinking in RED and BLUE alternately.
● While driving, if this indicator light/warning light behaves under any of the following conditions, take the specified appropriate measure listed below.
– Blinking in RED:
Decelerate the vehicle. After the blinking RED light turns off, you can drive the vehicle normally.
– Illuminated in RED:
Safely stop the vehicle as soon as possible, and refer to the emergency steps for the case of engine overheating. After that, have the system checked by your nearest SUBARU dealer. Refer to “Engine overheating” F9-12.
– Blinking in RED and BLUE alternately:
The electrical system may be malfunctioning. Contact your SUBARU dealer for an inspection.
This coolant temperature low indicator light/coolant temperature high warning light has the following three functions.
● Illumination in BLUE indicates insufficient warming up of the engine ● Blinking in RED indicates that the engine is close to overheating ● Illumination in RED indicates overheating condition of the engine
For the system check, this indicator light/ warning light illuminates in RED for approximately 2 seconds when the ignition switch is turned to the “ON” position. After that, this indicator light/warning light changes to BLUE and maintains illumination in BLUE. This BLUE illuminated light turns off when the engine is warmed up sufficiently.
If the engine coolant temperature increases over the specified range, the indicator light/warning light blinks in RED. At this time, decelerate the vehicle. After the blinking RED light turns off, you can drive the vehicle normally. However, if the indicator light/warning light often blinks in RED, the electrical system may be malfunctioning. Contact your SUBARU dealer for an inspection.
If the engine coolant temperature increases further, the indicator light/warning light illuminates in RED continuously. At this time, the engine may be overheating. Safely stop the vehicle as soon as possible, and refer to the emergency steps for the case of engine overheating. Refer to “Engine overheating” F9-12. After that, have the system checked by your nearest SUBARU dealer.
NOTE
If the engine is restarted after a certain driving condition, this indicator light/ warning light may illuminate in RED. However, this is not a malfunction if the indicator light/warning
READ NEXT:
Charge warning light
If this light illuminates when the engine is running, it may indicate that the
charging system is not working properly.
If the light illuminates while driving or does not turn off after the engin
Oil pressure warning light
CAUTION
Do not operate the engine with the oil pressure warning light on. This may cause
serious engine damage.
If this light illuminates when the engine is running, it may indicate that the
e
Engine low oil level warning light
The engine low oil level warning light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 2 seconds.
This light also illuminates when the en
SEE MORE:
Manual transmission
WARNING
● Do not drive the vehicle with the clutch disengaged (i.e., when the clutch
pedal is depressed) or with the shift lever in the neutral position. Engine braking
has no effect in either of these conditions and the risk of an accident is consequently
increased.
● Do not eng
Front Fender
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the bumper face assembly.
Remove the clips, turn over the front mud guard, and disconnect the fog
light connector. (Model with
fog light)
Remove the clips at the upper side of the bumper.
Remove the clips from the fender.
