Subaru Outback (BR): If the light is blinking
If the light is blinking while driving, an engine misfire condition has been
detected which may damage the emission control system.
To prevent serious damage to the emission control system, you should conform
to the following instructions.
● Reduce vehicle speed.
● Avoid hard acceleration.
● Avoid steep uphill grades.
● Reduce the amount of cargo, if possible.
● Stop towing a trailer as soon as possible.
The CHECK ENGINE warning light/malfunction indicator lamp may stop blinking and
illuminate steadily after several driving trips. You should have your vehicle checked
by an authorized SUBARU dealer immediately.
READ NEXT:
CAUTION
● After turning the ignition switch to the “ON” position, if this indicator light/warning
light behaves under any of the following conditions, the electrical system may be
malfu
If this light illuminates when the engine is running, it may indicate that the
charging system is not working properly.
If the light illuminates while driving or does not turn off after the engin
CAUTION
Do not operate the engine with the oil pressure warning light on. This may cause
serious engine damage.
If this light illuminates when the engine is running, it may indicate that the
e
SEE MORE:
Vehicles equipped with 4 non-unidirectional tires
1) Front
Vehicles equipped with unidirectional tires
1) Front
Tire wear varies from wheel to wheel. To maximize the life of each tire and ensure
that the tires wear uniformly, it is best to rotate the tires every 7,500 miles
(12,000 km).
Basic Diagnostic Procedure
A: PROCEDURE
General Description
A: CAUTION
CAUTION:
Do not use electrical test devices on any airbag
system wiring harnesses and connector
circuits.
Be careful not to damage the airbag system
wiring harness.
While diagnostic items are being checked, do
not opera
© 2010-2024 Copyright www.suoutback.com