Subaru Outback manuals

Subaru Outback: Seatbelt warning light and chime

Your vehicle is equipped with a seatbelt warning device at the driver’s and front passenger’s seat, as required by current safety standards.

With the ignition switch turned to the “ON” position, this device reminds the driver and front passenger to fasten their seatbelts by the warning lights in the locations indicated in the following illustration and a chime.

Driver’s warning light


Driver’s warning light

Front passenger’s warning light


Front passenger’s warning light

READ NEXT:

 Operation

If the driver and/or front passenger have/ has not yet fastened the seatbelt(s) when the ignition switch is turned to the “ON” position, the seatbelt warning light(s) will flash for 6 seconds,

 SRS airbag system warning light

When the ignition switch is turned to the “ON” position, the SRS airbag system warning light will illuminate for approximately 6 seconds and turn off. This shows the SRS frontal airbag and SRS

 Front passenger’s frontal airbag ON and OFF indicators

The front passenger’s frontal airbag ON and OFF indicators show you the status of the front passenger’s SRS frontal airbag. The indicators are located next to the clock in the center porti

SEE MORE:

 Engine low oil level warning light

The engine low oil level warning light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. This light also illuminates when the engine oil level decreases to the lower limit. The illuminating conditions and remaining oil level a

 Brake Hose

A: REMOVAL 1. FRONT BRAKE HOSE 1) Separate the brake pipe (b) from brake hose (a) using a flare nut wrench. 2) Remove the clamp, strut mounting bolt and union bolt, and remove the front brake hose. 2. REAR BRAKE HOSE 1) Remove the brake hose bracket bolt and union bolt. 2) Separate the brake pip

© 2010-2024 Copyright www.suoutback.com