Subaru Outback manuals

Subaru Outback: Odometer

This meter displays the odometer when the ignition switch is in the “ON” position.


This meter displays the odometer when the ignition switch is in the “ON” position. The odometer shows the total distance that the vehicle has been driven.

If you press the trip knob when the ignition switch is in the “LOCK” or “Acc” position, the odometer/trip meter will light up. If you do not press the trip knob within 10 seconds of illumination of the odometer/ trip meter, the odometer/trip meter will turn off.

Also, if you open and close the driver’s door within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off.

READ NEXT:

 Double trip meter

1) Trip knob This meter displays the two trip meters when the ignition switch is in the “ON” position. The trip meter shows the distance that the vehicle has been driven since you last set

 Tachometer

The tachometer shows the engine speed in thousands of revolutions per minute. CAUTION Do not operate the engine with the pointer of the tachometer in the red zone. In this range, fuel injection wi

 Fuel gauge

1) Low fuel warning light The fuel gauge shows the approximate amount of fuel remaining in the tank. When the ignition switch is in the “LOCK” or “Acc” position, the fuel gauge shows “E

SEE MORE:

 Read Diagnostic Trouble Code (DTC)

A: OPERATION NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor". For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)". <Ref. to PB(diag)- 35, List of Diagnostic Trouble Code (DTC).> Up to 3 DTCs are displayed in the

 Scan tuning (SCAN)

If you press the “SCAN” button, the radio will switch to the scan mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for 5 seconds while displaying the frequency, after which scanning will continue until the entire band

© 2010-2024 Copyright www.suoutback.com