Subaru Outback (BR): Shock sensors (dealer option)
The shock sensors trigger the alarm system when they sense impacts applied to the vehicle and when any of their electric wires is cut. The alarm system causes the horn to sound and the turn signal lights to flash for a short time when the sensed impact is weak, but it warns of a strong impact or multiple impacts by sounding the horn and flashing the turn signal lights, both lasting approximately 30 seconds.
If you desire, your SUBARU dealer can connect them and set them for activation or deactivation.
NOTE
● The shock sensors are not always able to sense impacts caused by breaking in, and cannot sense an impact that does not cause vibration (such as breaking the glass using a rescue hammer).
● The shock sensors may sense vibration like those shown in the following and trigger the alarm system. Select the settings of the alarm system and shock sensors appropriately depending on where you usually park your vehicle.
Examples:
– Vibration from construction site
– Vibration in multistory car park
– Vibration from trains
● You can have the sensitivity of the shock sensors adjusted to your preference
by your SUBARU dealer.
READ NEXT:
Child safety locks
WARNING
Always turn the child safety locks to the “LOCK” position when children sit on
the rear seat. Serious injury could result if a child accidentally opens the door
and falls out.
Each
Windows
WARNING
To avoid serious personal injury caused by entrapment, always conform to the
following instructions without exception.
● When operating the power windows, be extremely careful to pre
SEE MORE:
Loading your vehicle
WARNING
Never allow passengers to ride on a folded rear seatback, in the trunk or in
the cargo area. Doing so may result in serious injury.
WARNING
● Never stack luggage or other cargo higher than the top of the seatback because
it could tumble forward and injure passengers in the eve
High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the
air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the secured clip of the washer tank. To make it
easy to access the bulb, move the washer tank to the hor
