Subaru Outback (BR): To arm the system using power door locking switch
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate (Outback)) but leave only the driver’s door or the front passenger’s door open.
6. Press the front side (“LOCK” side) of the power door locking switch to set the door locks.
7. Close the door. An electronic chirp will sound once, the turn signal lights will flash once and the security indicator light will start flashing rapidly. After rapid flashing for 30 seconds (standby time), the security indicator light will then flash slowly (twice approximately every 2 seconds), indicating that the system has been armed for surveillance.
NOTE
● The system can be armed even if the engine hood, the windows and/or moonroof are open. Always make sure that they are fully closed before arming the system.
● The 30-second standby time can be eliminated if you prefer. Have it performed
by your SUBARU dealer. . If your vehicle is a Legacy and you open the trunk using
the remote transmitter’s “
” button with
the alarm system armed, the system will be temporarily placed in a standby state.
The system will go back to the surveillance state upon locking the trunk.
● The system is in the standby mode for a 30-second period after locking the doors with the remote transmitter. The security indicator light will flash at short intervals during this period.
● If any of the following actions is done during the standby period, the system will not switch to the surveillance state.
– Doors are unlocked using the remote transmitter.
– Any door (including the rear gate (Outback) or the trunk (Legacy)) is opened.
– Ignition switch is turned to the “ON” position.
READ NEXT:
Disarming the system
Briefly press the “” button (for
less than 2 seconds) on the remote transmitter. The driver’s door will unlock, an
electronic chirp will sound twice, the turn signal lights will flash twice
Emergency disarming
If you cannot disarm the system using the transmitter (i.e. the transmitter is
lost, broken or the transmitter battery is too weak), you can disarm the system
without using the transmitter.
The s
Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode,
the remote transmitter is used only for locking and unlocking the doors and rear
gate (Outback) and panic activati
SEE MORE:
Operating the driver’s window
1) Automatically open/close
2) Open/close
To open:
Press the switch down lightly and hold it. The window will open as long as the
switch is held.
This switch also has a one-touch auto down function that allows the window to
be opened fully without holding the switch. Press the switch down
D (Drive)
This position is for normal driving. The transmission automatically shifts into
a suitable gear according to the vehicle speed and the acceleration you require.
When more acceleration is required in this position, depress the accelerator pedal
fully to the floor and hold that position. The tra
