Subaru Outback (BR): Arming the system (remote transmitter and power door locking switch)
Subaru Outback (BR) 2010-2015 Owners Manual / Keys and doors / Alarm system / Arming the system (remote transmitter and power door locking switch)
READ NEXT:
To arm the system using remote transmitter
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid (
To arm the system using power door locking switch
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate (
Disarming the system
Briefly press the “” button (for
less than 2 seconds) on the remote transmitter. The driver’s door will unlock, an
electronic chirp will sound twice, the turn signal lights will flash twice
SEE MORE:
All-Wheel Drive warning light (AT and CVT models)
WARNING
Continued driving with the AWD warning light flashing can lead to powertrain
damage. If the AWD warning light flashes, promptly park in a safe place then check
whether all four tires are the same diameter and whether any of the tires has a
puncture or has lost air pressure for some
Turbo models
1) Air intake duct 2) Air cleaner case 3) Clamp
1. Remove the hydraulic hose in the power steering system from the clip on the
air intake duct.
2. Remove the hydraulic hose from the clip on the right side of the air cleaner
case.
3. Unsnap the two clamps holding the air cleaner case cover.
© 2010-2024 Copyright www.suoutback.com
