Subaru Outback (BR): If you have accidentally triggered the alarm system
To stop the alarm
Perform any of the following operations.
● Press any button on the remote transmitter.
● Turn the ignition switch to the “ON” position.
READ NEXT:
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid (
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate (
SEE MORE:
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Using the refrigerant recovery system, discharge refrigerant. <Ref. to AC-24,
PROCEDURE, Refrigerant
Recovery Procedure.>
3) Drain the coolant from the radiator.
H4 non-turbo model: <Ref. to CO(H4SO)-14, DRAINING OF ENGINE COOL
A: REMOVAL
1) Lift up the vehicle, and then remove the front wheels.
2) Remove the axle nut.
CAUTION:
Do not loosen the axle nut while the front axle is loaded. Doing so may damage
the hub bearing.
Lift the crimped section of axle nut.
Remove the axle nut using a socket wrench while depressing
© 2010-2024 Copyright www.suoutback.com