Subaru Outback: Choosing a child restraint system
Choose a child restraint system that is appropriate for the child’s age and size
(weight and height) in order to provide the child with proper protection. The child
restraint system should meet all applicable requirements of Federal Motor Vehicle
Safety Standards for United States or Canada Motor Vehicle Safety Standards for
Canada. It can be identified by looking for the label on the child restraint system
or the manufacture’s statement of compliance in the document attached to the system.
Also it is important for you to make sure that the child restraint system is compatible
with the vehicle in which it will be used.
READ NEXT:
WARNING
● Child restraint systems and seatbelts can become hot in a vehicle that has
been closed up in sunny weather; they could burn a small child. Check the child
restraint system before
1. Place the child restraint system in the rear seating position.
2. Run the lap and shoulder belt through or around the child restraint system
following the instructions provided by its manufact
1. Place the child restraint system in the rear seating position.
2. Run the lap and shoulder belt through or around the child restraint system
following the instructions provided by its manufact
SEE MORE:
1) Power steering fluid reservoir (page 11-27)
2) Manual transmission oil level gauge (MT) (page 11-23)
3) Clutch fluid reservoir (page 11-29)
4) Brake fluid reservoir (page 11-28)
5) Fuse box (page 11-46)
6) Battery (page 11-45)
7) Windshield washer tank (page 11-40)
8) Engine oil filler c
The security indicator light deters potential thieves by indicating that the
vehicle is equipped with an immobilizer system. It begins flashing approximately
60 seconds after the ignition switch is turned from the “ON” position to the “Acc”
or “LOCK” position or immediately after
© 2010-2024 Copyright www.suoutback.com