Subaru Outback (BR): Front fog light (if equipped)
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Pull off the fender lining. Refer to “Pulling off the fender lining” F11-7.
2. Disconnect the electrical connector.
1) For left-hand side
2) For right-hand side
3. Turn the socket clockwise (right-hand side) or counterclockwise (left-hand
side).
4. Pull out the socket.
5. Pull out the bulb from the socket and replace the bulb with a new one.
6. After replacing the bulb, reattach the fender lining.
READ NEXT:
Legacy
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn the knobs of the cover 90 degrees counterclockwis
1. Apply a flat-head screwdriver to the light cover as shown in the illustration,
and pry the light cover off from the rear gate trim.
1) Back-up light
2) Tail light
2. Turn the bulb socket c
SEE MORE:
Your vehicle is designed and intended to be used primarily as a passenger-carrying
vehicle. Towing a trailer puts additional loads on your vehicle’s engine, drivetrain,
brakes, tires and suspension and has an adverse effect on fuel economy.
If you do decide to tow a trailer, your safety and s
CAUTION
● Do not pick up a bottle from the bottle holder or put a bottle in the holder
while you are driving, as this may distract you and lead to an accident.
● When placing a beverage in a door pocket, make sure it is capped. Otherwise,
the beverage could spill when opening/closi
© 2010-2024 Copyright www.suoutback.com