Subaru Outback (BR): Maintenance tips
Some clips and fender linings must be removed before replacing the air cleaner
elements or specific bulbs.
READ NEXT:
Removing clips
There are several types of clips used for your vehicle
Type A clips
1. Turn the clips counterclockwise using a flat-head screwdriver until the center
portion of the clip is raise
Use a screwdriver to undo the clips on the air intake duct, then remove the air
intake duct. Refer to “Type A clips” F11-5.
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the eng
SEE MORE:
A: REMOVAL
CAUTION:
Directly after the vehicle has been running or the engine has been
long idle running, the CVTF is
hot. Be careful not to burn yourself.
Be careful not to spill CVTF on the exhaust pipe to prevent it from
emitting smoke or causing a fire.
If gear oil adheres, wipe it off
1) Low fuel warning light
The fuel gauge shows the approximate amount of fuel remaining in the tank. When
the ignition switch is in the “LOCK” or “Acc” position, the fuel gauge shows “E”
even if the fuel tank contains fuel.
The gauge may move slightly during braking, turning or a
© 2010-2024 Copyright www.suoutback.com