Navigation monitor (if equipped)

To clean the navigation monitor, wipe it with a silicone cloth or with a soft cloth. If the navigation monitor is extremely dirty, clean it with a soft cloth moistened with neutral detergent then carefully wipe off any remaining detergent.

NOTE

● Do not spray neutral detergent directly onto the monitor. Doing so could damage the monitorТs components.

● Do not wipe the monitor with a hard cloth. Doing so could scratch the monitor.

● Do not use cleaning fluid that contains thinner, gasoline, or any other volatile substance. Such cleaning fluid could erase the lettering on the switches at the bottom of the monitor.

    See also:

    Checking the fluid level when the fluid is cold
    When the fluid level has to be checked without time to warm up the automatic transmission, check to see that the fluid level is between the lower level and upper level on the УCOLDФ range. If it is be ...

    Breaking-in of new brake pads and linings
    When replacing the brake pad or lining, use only genuine SUBARU parts. After replacement, the new parts must be broken in as follows: ...

    Airflow mode selection button
    Select the desired airflow mode by pressing the airflow mode selection button. The selected airflow mode is shown on the display. There are four airflow modes that activate the following air outl ...