Subaru Outback (BR): Cleaning aluminum wheels
● Promptly wipe the aluminum wheels clean of any kind of grime or agent. If dirt
is left on too long, it may be difficult to clean off.
● Do not use soap containing grit to clean the wheels. Be sure to use a neutral
cleaning agent, and later rinse thoroughly with water. Do not clean the wheels with
a stiff brush or expose them to a high-speed washing device.
● Clean the vehicle (including the aluminum wheels) with water as soon as possible
when it has been splashed with sea water, exposed to sea breezes, or driven on roads
treated with salt or other agents.
READ NEXT:
Your SUBARU has been designed and built to resist corrosion. Special materials
and protective finishes have been used on most parts of the vehicle to help maintain
fine appearance, strength, and r
The most common causes of corrosion are:
1. The accumulation of moisture retaining dirt and debris in body panel sections,
cavities, and other areas.
2. Damage to paint and other protective coatin
Wash the vehicle regularly to prevent corrosion of the body and suspension components.
Also, wash the vehicle promptly after driving on any of the following surfaces.
● roads that have been s
SEE MORE:
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5.
4. Pull off
1. Sit well back in the seat.
2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted.
If the belt stops before reaching the buckle, return the belt slightly and pull
it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly
after givi
© 2010-2024 Copyright www.suoutback.com