Subaru Outback: How to re-stow bars
CAUTION
Do not use the bars as roof rails when the bars are stowed.
1. Pull out the crossbars from the roof rail holders by pulling up the covers.
2. Slide the bars in the direction shown in the illustration.
3. Install the bars into the holders.
4. Make sure that the latches are fitted securely.
READ NEXT:
WARNING
● Never exceed the maximum weight specified for the trailer hitch. Exceeding
the maximum weight could cause an accident resulting in serious personal injuries.
Permissible trailer w
1. Remove the receiver cover from the hitch receiver tube. Then insert the ball
mount into the hitch receiver tube.
2. Insert the hitch pin into the hole on the hitch receiver tube so that the
● Remove the ball mount from the hitch receiver tube and insert the receiver
cover onto the hitch receiver tube.
● Place the dust cap over the four-pin connector of the hitch wire harne
SEE MORE:
A: SPECIFICATION
1. TORQUE CONVERTER
2. OIL PUMP
3. TRANSMISSION CONTROL ELEMENT
4. TRANSMISSION GEAR RATIO
5. PLATE
6. SELECTOR POSITION
7. HYDRAULIC CONTROL AND LUBRICATION
8. COOLING AND HARNESS
9. TRANSFER
10.REDUCTION GEAR RATIO
11.RECOMMENDED GEAR OIL
B: COMPONENT
1. TORQUE CONVERTE
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the center exhaust pipe. <Ref. to EX(H4SO)-8, REMOVAL, Center Exhaust
Pipe.>
4) Remove the heat shield cover.
5) Set the transmission jack under the transmission. Make sure that the
support plate of
© 2010-2024 Copyright www.suoutback.com