Subaru Outback (BR): Winter driving on 2.5 L turbo models
Original equipment summer tires are installed on your vehicle, which are not suitable for driving on slippery surfaces like snow-covered or icy roads. Compared to winter and all-season tires, summer tires provide much less traction on snowy and icy roads. Therefore, it is highly recommended to use winter tires when encountering such road conditions.
If you opt for winter tires, ensure they are the correct size and type for your vehicle. Install four winter tires that match in size, construction, brand, and load range, and avoid mixing radial, belted bias, or bias tires as this could lead to unsafe handling characteristics. Additionally, check that there is sufficient clearance between the tire and the vehicle body when selecting a tire.
Always drive cautiously regardless of the tire type on your vehicle to ensure safety on the road.
READ NEXT:
Tire chains
CAUTION
Tire chains cannot be used on any tires for your Legacy and Outback because of
lack of clearance between the tires and vehicle body.
Rocking the vehicle
If you must rock the vehicle to free it from snow, sand, or mud, depress the
accelerator pedal slightly and move the shift lever/select lever back and forth
between “1”/“D” and “R” rep
Loading your vehicle
WARNING
Never allow passengers to ride on a folded rear seatback, in the trunk or in
the cargo area. Doing so may result in serious injury.
WARNING
● Never stack luggage or other cargo hi
SEE MORE:
SRS airbag system warning light
When the ignition switch is turned to the “ON” position, the SRS airbag system
warning light will illuminate for approximately 6 seconds and turn off. This shows
the SRS frontal airbag and SRS side airbag and SRS curtain airbag and seatbelt pretensioners
are in normal operation.
WARNING
Windshield washer fluid
CAUTION
Never use engine coolant as washer fluid because it could cause paint damage.
If you spray washer fluid on the windshield but the windshield washer fluid warning
light illuminates or the supply of washer fluid runs out, add washer fluid in the
tank.
Remove the washer tank filler
