Subaru Outback (BR): To increase the speed (by the “RES/ SET” switch)
Press the “RES/SET” switch to the “RES” side and hold it until the vehicle reaches
the desired speed. Then, release the switch. The vehicle speed at that moment will
be memorized and treated as the new set speed.
U.S.-spec. models
When the difference between the actual vehicle speed and the set speed is less
than 4 mph (6.8 km/h), the set speed can be increased 1 mph (1.6 km/h) each time
by pressing the “RES/SET” switch to the “RES” side quickly.
Canada-spec. models
When the difference between the actual vehicle speed and the set speed is less
than 4.4 km/h, the set speed can be increased 1 km/h each time by pressing the “RES/SET”
switch to the “RES” side quickly.
READ NEXT:
1. Depress the accelerator pedal to accelerate the vehicle to the desired speed.
2. Press the “RES/SET” switch to the “SET” side once. Now the desired speed is
set and the vehicle will keep
Press the “RES/SET” switch to the “SET” side and hold it until the vehicle reaches
the desired speed. Then, release the switch. The vehicle speed at that moment will
be memorized and tre
1. Depress the brake pedal to release cruise control temporarily.
2. When the speed decreases to the desired speed, press the “RES/SET” switch
to the “SET” side once. Now the desired speed
SEE MORE:
1) Support
1. Grasp the locked end of the blade rubber assembly and pull it firmly until
the stoppers on the rubber are free of the support.
1) Metal spines
2. If the new blade rubber is not provided with two metal spines, remove the
metal spines from the old blade rubber and install them
CAUTION
Always remove the head restraint when mounting a child restraint system with
a top tether. Failure to do so may prevent the top tether from being fastened tightly.
Outback
1. Remove the head restraint at the seating position where the child restraint
system has been installed with t
© 2010-2024 Copyright www.suoutback.com