Subaru Outback (BR): To change the cruising speed
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Cruise control / To change the cruising speed
- To increase the speed (by the “RES/ SET” switch)
- To increase the speed (by accelerator pedal)
- To decrease the speed (by the “RES/SET” switch)
- To decrease the speed (by brake pedal)
READ NEXT:
To increase the speed (by the “RES/ SET” switch)
Press the “RES/SET” switch to the “RES” side and hold it until the vehicle reaches
the desired speed. Then, release the switch. The vehicle speed at that moment will
be memorized and tre
To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to accelerate the vehicle to the desired speed.
2. Press the “RES/SET” switch to the “SET” side once. Now the desired speed is
set and the vehicle will keep
To decrease the speed (by the “RES/SET” switch)
Press the “RES/SET” switch to the “SET” side and hold it until the vehicle reaches
the desired speed. Then, release the switch. The vehicle speed at that moment will
be memorized and tre
SEE MORE:
Center Differential Carrier
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Remove the rear vehicle speed sensor, and separate
the extension case from transmission case.
<Ref. to 5AT-65, REMOVAL, Extension Case.>
3) Extract the rear
Front Speaker
A: REMOVAL
1. FRONT SIDE SPEAKER
1) Disconnect the ground cable from battery.
2) Remove the front side speaker.
Release the clips and claws, then detach the speaker cover.
CAUTION:
Use a plastic clip remover for removal.
Remove the screws.
Preparation tool: Stubby screwdriver
Disconnect the
© 2010-2024 Copyright www.suoutback.com
