Subaru Outback (BR): ABS system self-check
You may feel a slight shock in the brake pedal and hear the operating sound of
ABS from the engine compartment just after the vehicle is started. This is caused
by an automatic functional test of the ABS system being carried out and does not
indicate any abnormal condition.
READ NEXT:
The ABS warning light illuminates when the ignition switch is turned to the “ON”
position and turns off after approximately 2 seconds.
This is an indication that the ABS system is working pro
The EBD system maximizes the effectiveness of the brakes by allowing the rear
brakes to supply a greater proportion of the braking force. It functions by adjusting
the distribution of braking forc
If a malfunction occurs in the EBD system, the system stops working and the brake
system warning light and ABS warning light illuminate simultaneously.
The EBD system may be malfunctioning if the
SEE MORE:
A: LOCATION
NOTE: For other related fuses, refer to the wiring diagram. <Ref. to WI-15, Power Supply Circuit.>
B: INSPECTION
1. CHECK FUSE.
1) Remove the fuse and inspect visually.
2) If the fuse is blown out, replace the fuse.
NOTE: If the fuse is blown again, check the system wiri
A: REMOVAL
1) Remove the front pillar trim.
Pull the upper part of the front pillar trim towards the center of the
vehicle.
Insert long-nose pliers into the top part of the trim, grip the clip
with the pliers and twist 90º in that position.
CAUTION:
Be careful not to damage the pillar trim
© 2010-2024 Copyright www.suoutback.com