Subaru Outback (BR): Two separate circuits
Your vehicle has a dual circuit brake system. Each circuit works diagonally across
the vehicle. If one circuit of the brake system should fail, the other half of the
system still works. If one circuit fails, the brake pedal will go down much closer
to the floor than usual and you will need to press it down much harder. And a much
longer distance will be needed to stop the vehicle.
READ NEXT:
WARNING
Do not be overconfident about the brake assist. It is not a system that brings
more braking ability to the vehicle beyond its braking capability. Always use the
utmost care when driving r
The disc brake pad wear warning indicators on the disc brakes give a warning
noise when the brake pads are worn.
If a squeaking or scraping noise is heard from the disc brakes while braking,
im
SEE MORE:
If the select lever cannot be operated, turn the ignition switch back to the
“ON” position then move the select lever to the “P” position with the select lever
button pressed and brake pedal depressed. If the select lever does not move after
performing the above procedure, perform the
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate (Outback)) but leave only the driver’s door
or the front passenger’s door open.
6. Press the
© 2010-2024 Copyright www.suoutback.com