Subaru Outback: Pre-heating or pre-cooling the interior of the vehicle
Models with automatic climate control system:
After the system starts the engine, the automatic climate control system will
activate the “FULL AUTO” mode and heat or cool the interior to the predetermined
median (room) temperature. No presetting of controls is necessary.
Models with manual climate control system:
Before exiting the vehicle, set the temperature controls to the desired setting
and operation. After the system starts the engine, the heater or air conditioning
will activate and heat or cool the interior to your setting.
READ NEXT:
In service mode, the remote engine start function is temporarily disabled to
prevent the system from unexpectedly starting the engine while being serviced.
To engage or disengage service mode:
1.
New transmitters can be programmed to the remote engine start system in the event
that a transmitter is lost, stolen, damaged or additional transmitters are desired
(the system will accept up to e
NOTE
In the event that the vehicle’s battery is replaced, discharged or disconnected,
it will be necessary to start the vehicle a minimum of one time using the key prior
to activating the remot
SEE MORE:
1) U.S.-spec. models
2) Except U.S.-spec. models
This indication shows the average rate of fuel consumption since the trip meter
was last reset.
Pressing the trip knob toggles the indication between the average fuel consumption
corresponding to the A trip meter indication and the average fu
A: SPECIFICATION
B: COMPONENT
1. STEERING WHEEL AND COLUMN
Bushing
Insulator (CVT model)
Steering shaft
Knee protector
Steering roll connector
Column cover
Steering wheel lower cover
Paddle shift
Steering wheel
Switch
Protector
Dynamic damper
Airbag module
Tightening torque:N*m (k
© 2010-2024 Copyright www.suoutback.com